This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installation issues

I cannot seem to get xg firewall to install properly. I burned the iso onto the memory stick, set my bios to legacy boot, booted the usb drive, installed it then it doesn't recognise the hdd as bootable. i've tried 3 different hdd's in 2 different computer with 2 different thumb drives. The iso isn't borked because the same iso worked fine in a vm and it booted perfectly, so i must be doing something wrong

What should i do

This thread was automatically locked due to age.

0 Harry Herring over 7 years ago

Ok, i got it working with the easy2boot workaround, but this has thrown me into a second problem, how do i install the drivers for my asix AX88772B Nic? I assume it's the one that's not being detected. the shell is very stripped back, but i've got 200gb of space so installing extra stuff isn't an issue
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 7 years ago in reply to Harry Herring

Hi,

what chipset is the NIC? There is a thread sometime back about installing NIC drivers, my search ability is not very good. But you would need to do this after every upgrade I think?

Ian
Cancel
Vote Up 0 Vote Down

Cancel