Thread Info
  • State Suggested Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 7 replies
  • Answers 1 answer
  • Subscribers 29 subscribers
  • Views 11291 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem with DNAT Rule

Christian Rogne

I have successfully made a DNAT rule for my Geofency, and can NAT it into the right IP and get access. But if I want to set access to one specific MAC addresse I cant connect.

See attached picture

 

 

Regards from 

Christian



This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    I also use Geofency with a DNAT Rule to forward a port to a specific raspberry on the network. But I have the problem, that the traffic is getting blocked if I forward one port only. If I forward any services it is working without any problems. Could you post Screenshots from your config? Do you have any idea why it is not working, did you have similar problems in the beginning?

    Thank you for your help.

    Marc

Reply
  • 0

    Hi,

    I also use Geofency with a DNAT Rule to forward a port to a specific raspberry on the network. But I have the problem, that the traffic is getting blocked if I forward one port only. If I forward any services it is working without any problems. Could you post Screenshots from your config? Do you have any idea why it is not working, did you have similar problems in the beginning?

    Thank you for your help.

    Marc

Children