All,
Blink Cameras are cool little battery operated WiFi cameras you can stick anywhere and control via a slick little app. Well, I couldn't for the life of me get this to work with UTM 9.5 when I had web filtered enabled. But it turns out with some tweaking in XG I was able to make it work! WhooHoo! So for anyone that's in the same boat I hope you find this useful!
First go into Hosts and Services and create an Network list of the following IPs (these work as of the post):
52.206.108.91
52.206.9.53
34.226.46.237
34.195.184.66
54.152.110.25
54.164.211.5
23.239.26.89
34.197.51.32
Save then then head over to your Firewall rules and create a new rule as follows:
Source Zone: LAN or wherever the camera sits
Source Networks: If you so choose
Destination Zone: WAN most likely
Destination Networks: The Network List you just created
Service: Any
Identity: Do not check
Malware/Content Scanning: All Unchecked
IPS: None
Shaping: None
Web Policy: None
App Control: None
Normal NAT Rules
Log It
Save, then here's the important part! You must move this rule above your normal outbound access rule then this rule will hit first!
Once you do that you should be golden!
-Rogue
This thread was automatically locked due to age.