Hi community,
Today I'm facing couple of issues with the failover groups for IPSec Site-to-Site connections with 2 differents appliances since the last firmware upgrade (SFOS 17.0.1 MR-1). All the connections works fine and where tested one by one succesfully. But when I configure and "Activate" the failover group always get issues.
For a XG105 it says that the failover group where activated succesfully but it never shows as activated or even tries to established the connection with the remote appliance. And for the other office there is a XG125, facing a different issue with the failover group, it works fine at the first time it is configured and activated, it shows as active in failover section but does not appear any sign in the IPsec connections, but in the remote appliance (XG105) it shows the connection activatedm although after a time has passed or if I try to modify the failover order it stops working and starts getting the same issue as the XG105 initially mentioned.
I think it might be a bug over the new firmware realease.
But I'm opened to hear advices if I'm the one that is configuring this in a bad way.
Rgds.
This thread was automatically locked due to age.
