Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 28 subscribers
  • Views 5424 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Update SG135 to XG - Only physical eth1 is enable on interfaces screen

Yann LEDUC1

Hi,

 

I had upgrade my sg135 from utm to xg firmware.

 

On the interfaces screen i just see eth1

But on zone screen I see all interfaces on LAN members

 

Can you help me ?

Yann



This thread was automatically locked due to age.
Parents
  • 0

    Hey  

    From the screenshots, it appears you have bridged interface (br0) that has combined most of your interfaces.
    You can delete this bridge if you would like to configure each ethernet port separately.

    Regards,

    FloSupport | Community Support Engineer

Reply
  • 0

    Hey  

    From the screenshots, it appears you have bridged interface (br0) that has combined most of your interfaces.
    You can delete this bridge if you would like to configure each ethernet port separately.

    Regards,

    FloSupport | Community Support Engineer

Children
No Data