Communicate from LAN1 over WAN1 to WAN2 via DNAT to LAN2

Michael,

please share screenshot of both LAN 1 and LAN2 firewall rules.

Regards

Hi Luk,

 I tried to connect from ID 5 to ID 2 (over ID 7)

I will not open LAN1 to LAN2 internaly, because the networks should not see each other.

Then simply configure a Firewall Rule to communicate between the LAN# network and the Server IP (create a IP host definition in the destination network), instead of defining ANY in the destination or source zone.

Thanks

HI Sachin,

I'm not sure how you meaning that.

Can you make a example rule as screenshot for me, please?

And I need the rules to fix the outgoing WAN address per lan interface.

Check this, any help?

Yes it works, thanks.

But it is not this what I prefer to do.

My destination is, that the internal LAN interfaces are seperated from each other. I will
Is there no possibility to go out from one WAN interface and come in into the other WAN interface?

Maybe with routing?

I would be glad if there is anything what I can do.

Hi Michael,

In my suggested way, you are still not keeping different LAN separated. In your way, you just need a LAN to WAN FW-rule with MASQ defined. Finally, a DNAT rule to route any traffic from WAN to the destination inside LAN (server IP). 

Thanks

Hi Michael,

In my suggested way, you are still not keeping different LAN separated. In your way, you just need a LAN to WAN FW-rule with MASQ defined. Finally, a DNAT rule to route any traffic from WAN to the destination inside LAN (server IP). 

Thanks