Sophos XG firewall virtual appliance not working on Hyper-V environment

Hi All.

I have setup a Sophos XG Virtual Appliane on a Hyper-V environment. The problem I have is I need it to be working in Bridge Mode. I have set Port A=LAN and Port B=WAN, the interfaces I have set for bridge mode. I have a Cisco router with, for the sake of example, IP address 192.168.110.1 that serves as the gateway for internet use.  By the way I have a /23 subnet mask.

I plugged Port B to router using a crossover cable; and I plugged Port A to a Cisco Catalyst switch where the PC is connected. I set Sophos as Bridge Mode and set an IP 192.168.111.254/23 for Sophos. And, of course, the gateway IP is the Cisco router which is 192.168.110.1. I created an initial policy LAN to WAN with allow all to make sure that nothing is filtered for now and will put the filters later once I know that Bridge mode is working accordingly.

Now, my problem is upon connecting a PC to the switch (same subnet as the router, and on the manage switch for this) and monitoring the dashboard of Sophos admin, I can see traffic going to the interfaces as seen on the snapshot

Issue though is that I'm lockout meaning I can't browse, can't even reach the gateway using ping, so cut it short no internet services.

Had been reading blog, that Pure Bridge isn't supported on a Hyper-V environment, is this correct?