Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Question regarding VLANs

My limited experience with networking involves Cisco, so bare with me on this.

 

I'm not understanding why I need to IP an interface after I've created a VLAN on that same interface.The only way I can get this to work is if I put some bogus IP on the physical interface.

My actual DMZ network below is 10.0.41.0/24. What I'm used to is creating a subinterface, IPing that, and leaving nothing on the actual physical interface. I'm sure I'm missing something here but I'm not sure of what.

 



This thread was automatically locked due to age.
  • Hi,

     

    Is your deployment a "router on a stick" ? , can you please further more explain the issues you are specifically encountering

     

     

    Regards,

     

    Rap 

  • Seth,

    XG does not support VLAN layer 2. So for each VLAN, you need to assign an IP and so you have a layer 3 subinterface.

    XG is not acting as a switch.

    For those features, you still need a switch.

    Regards

  • Hi Seth,

    What you are doing is the correct way to implement a VLAN on an interface that does not have a native VLAN (or isn't used) on a Sophos XG device. The 'primary/physical' interface must have an IP address set, however it does not need to be valid (or used). I believe we have used IPs in the 127.0.0.10-40 range before, or at least a range that is never used. Your example, including a 255.255.255.255 subnet mask is perfect.

    I would also consider creating a separate zone for the physical interface for the ultimate security - no services bound under appliance access, and no rules created.

    Kind Regards;

    Dave