Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to access Sophos XG administration console when in Bridge Mode?

Hi all,

This is my first post, so I hope it will work out.

So I wanted to put my Sophos XG home (running on UTM 110/120 hardware) into transparent bridge mode and I followed this instruction (in order to prevent dual NAT):

https://community.sophos.com/kb/en-us/122973

After succesfully changing the settings on sophos XG via the administration console 172.16.16.16, now the following questions arise:

  1. how do I access the XG administration console when in transparent bridge mode?
  2. i can not access the internet from the LAN side anymore, is the instruction not sufficient enough to do LAN-to-WAN traffic?
  3. how does the XG get its pattern and/or firmware updates?

Hope you guys can help me out!

[8-|]

 



This thread was automatically locked due to age.
Parents
  • M,

    welcome to Sophos Community.

    Make sure you can ping the IP address configured on XG bridge by an internal host. You can check the XG ip using Console options.

    A LAN to WAN firewall rule is enough. Check firewall rules under Firewall menu and use log viewer to understand what is wrong.

    Regards

Reply
  • M,

    welcome to Sophos Community.

    Make sure you can ping the IP address configured on XG bridge by an internal host. You can check the XG ip using Console options.

    A LAN to WAN firewall rule is enough. Check firewall rules under Firewall menu and use log viewer to understand what is wrong.

    Regards

Children
No Data