This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bridge Mode - Can't ping devices from XG on local LAN. Local LAN can ping the XG fine

Setting up a XG for my home lab and can't quite understand this.

Everything seems to be working as needed but I can't ping or send syslog to anything on the LAN interface. BUT I'm able to ping the XG and pull SNMP from it from a host on the LAN.

So Host 1 can ping the XG. But the XG can't ping Host 1.

Any thoughts? Arp tables on the XG don't seem incorrect.

This thread was automatically locked due to age.

Parents

0 DavidWilliams1 over 8 years ago

I'm in Bridge Mode and do not have any issues with Ping or Syslog to the LAN. A couple of observations:

1) Not sure about that Port 3 in the LAN Zone. Would that be right? I only have 2 physical on the box.

2) Under interfaces, I only see br0 on my box. The physical interfaces do not show up, as your do. Not sure why that is. I'm on 16.05.5 MR-5

3) Here is what my Zones look like. No FW rules were added to make Ping or Syslog work to LAN devices.
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 8 years ago in reply to DavidWilliams1

Seth,

use tcpdump to understand where is the ping going. As David shared (thanks David) the bridge configuration works as David's configuration.
Cancel
Vote Up 0 Vote Down

Cancel
0 Seth Malchow over 8 years ago in reply to lferrara

The traffic isn't reaching the intended destination devices on the LAN. Doesn't appear to be leaving the bridge interface.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Seth Malchow over 8 years ago in reply to lferrara

The traffic isn't reaching the intended destination devices on the LAN. Doesn't appear to be leaving the bridge interface.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data