This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Power on after outage

It occurred to me this morning that the XG units have a power button, which our old routers did not. Is there any way to set them to automatically power back up after a power cut?

I haven't actually checked, I guess the default state could be return to last power state and it will sort itself out.

I could have a problem with remote offices if this isn't an option.

Thanks.

This thread was automatically locked due to age.

Parents

0 lferrara over 8 years ago

Tom,

you have to check inside the BIOS if there is such a option.

I am using XG at home on a barebone and the option is in the BIOS.

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 Tom Sparrow over 8 years ago in reply to lferrara

Thanks, I meant on the Sophos XG hardware though, not SW install on a mini PC (though I too have one of those at home now, and ought to check that tonight).

I guess I could connect the console and see what is there on boot, but I'm hoping not to have to go down that line unless someone tells me that's where to look.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Tom Sparrow over 8 years ago in reply to lferrara

Thanks, I meant on the Sophos XG hardware though, not SW install on a mini PC (though I too have one of those at home now, and ought to check that tonight).

I guess I could connect the console and see what is there on boot, but I'm hoping not to have to go down that line unless someone tells me that's where to look.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data