Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 28 subscribers
  • Views 9088 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG Firewall Firmware Update in HA config

GabrieleD

Hello, Quick Question:

When new firmware are applied what is the sequence in SFOS XG?

When firmware is applied, is it performed in one device at a time without service loss or both with loss of service?

In Cyberoam HA there is loss of service

In Sophos UTM there is no loss of service

Thanks

 

 



This thread was automatically locked due to age.
Parents
  • 0

    I found this hard to figure out too. When updating XG it will only do one HA member at a time and fail over, there is one caveat however, if you upload a firmware and you don't select Upload & Boot you later have to reboot both members simultaneously.

Reply
  • 0

    I found this hard to figure out too. When updating XG it will only do one HA member at a time and fail over, there is one caveat however, if you upload a firmware and you don't select Upload & Boot you later have to reboot both members simultaneously.

Children