Bridge/Transparent mode deployment XG.

John, make sure XG is able to ping google and the gateway.

Check arp table from console command.

Regards

I have Port2 and Port3 in the Bridge Port, I notice that if I connect the LAN link (Port3) only, my gateway link works fine but if I connect both links (Port2 and Port3) the WAN link (Port2) goes down.

Traffic still goes through and I can see the allowed packets.

Also, "HTTP 500 ERROR" when try to browsing internet and can't access any HTTPS site.

I have Port2 and Port3 in the Bridge Port, I notice that if I connect the LAN link (Port3) only, my gateway link works fine but if I connect both links (Port2 and Port3) the WAN link (Port2) goes down.

Traffic still goes through and I can see the allowed packets.

Also, "HTTP 500 ERROR" when try to browsing internet and can't access any HTTPS site.

Hi John,

Show us the inside configuration of the gateway in the WAN link manager and Bridge port configuration.

Thanks

Hi sachingurung,

Thank for your reply, here you have the configuration of both ports.

WAN link:

Bridge port:

Thank you.

For the WAN link manager, edit the failover rule and ping to 8.8.8.8. Does that make the gateway green? Alongside, uncheck the "routing on bridge interface" save the config and verify if that resolves it. 

Thank you,

It does fix the certificate problem I was having but I still see the WAN link status down.

EDIT: Also, I can't ping 8.8.8.8 or my gateway (10.99.1.1) through the bridge or PortA2 (WAN link).

I've heard you need to setup a firewall rule to allow communication from one interface to another. Do you have a firewall rule to allow communication between the lan and wan?

Not sure if this is taken care of when setting up a bridge, but figured it was worth a mention.

Hi John,

Uncheck 'unable routing on this bridge pair' option in the bridge interface definition. If that doesn't resolve the issue then please DM me and we will investigate further. 

Thanks