Connected to VPN but no traffic to LAN

Jenson,

thanks for the screenshot. Remove the Port#1 and there add your internal resources you want to access. Download the SSL Configuration to make sure client is using the correct config.

This is required everytime you change the SSL VPN config.

Regards

I can't get this to work :/ what am I doing wrong?

what is also interesting, why is so difficult to set up? you go step by step, read all posts and still have troubles accessing local network... any ideas?

Jerzy,

What is not working?

Are you able to ping a LAN ip resource?

Thanks

You have to create firewall rules from LAN -> VPN and VPN -> LAN for this to work.

lferrara,
no, i am not able to ping anything :/
once i am connected to my VPN site all traffic gets blocked including LAN and WAN (I have it configured as 'Use as Default Gateway')
tried from scratch few times already and nothing helps ...
here is screenshot of my rule. Thanks in advance for your help

i tired that before, tried again now and nothing, still does not work, cannot ping anything on lan (192.168.3.0) but the VPN IPv4 Lease Range is set to 192.168.4.220-192.168.4.229.... i do not quite understand how the firewall would connect both networks? is that the case here?

i tired that before, tried again now and nothing, still does not work, cannot ping anything on lan (192.168.3.0) but the VPN IPv4 Lease Range is set to 192.168.4.220-192.168.4.229.... i do not quite understand how the firewall would connect both networks? is that the case here?

Same problem here. Have rebuilt the SSL VPN multiple times from scratch and the entire XG setup. I think it has to do with firewall rules or how the XG is routing traffic. Still not sure though.