initial setup from serial console

Question

I need a workflow for new XG's out of the box that will get just enough basic configuration done over a serial console to then permit someone to remotely complete the setup through the web interface via a public ip configured on the wan port. Example is an XG115W with SFOS 16.05.1 MR-1 Build 139 and we will be using it in gateway mode. What commands could accomplish this?

This thread was automatically locked due to age.

onward · Accepted Answer

Thanks for your helpful pointers, mission accomplished: 38400 8n1 serial console >> network configuration >> interface configuration menu cannot set wan Port2 static ip prior to web interface activation + setup, this screen only shows that it's hardcoded for dhcp system configuration >> set password for user admin XG115w_XN02_SFOS 16.05.1 MR-1# ifconfig Port2 my.wan.ip.here netmask 255.255.255.240 XG115w_XN02_SFOS 16.05.1 MR-1# route add default gw my.wan.gateway.ip.here confirm changes are reflected in output of ifconfig and route commands Console>system appliance_access enable note: the ip, route, and access changes are lost each time system reboots prior to full setup completion through the web interface browse to https://wan.ip:4444 , go through activation and setup, system reboots Console>system appliance_access enable configure proper firewalling + local service ACL's for remote access through web interface update firmware SFOS 16.05.1 MR-1 to SFOS 16.05.3 MR-3 through web interface

lferrara · Answer

Hi, 
 AFAIK configuring Cyberoam was possibile through COM port but I am not sure if you can do the same with XG. 
 You can find CLI commands here: 
 https://www.sophos.com/en-us/medialibrary/PDFs/documentation/SophosFirewall/v16/SF-OS-Command-Reference-Guide.pdf?la=en 
 At the beginning, you have to activate your XG by entering the Activating code. I did using VGA connection and then you can edit the ports and IP addresses. 
 Regards

Aditya Patel · Answer

Hi onward 
 By default, the XG will have the following interface configuration. 
 Port1 LAN IP 172.16.16.16/24 port 2 WAN IP DHCP Port 3 onwards unconfigured. 
 If you wish to access the device from WAN you may need to connect to a public IP which is assigned via DHCP. The static address cannot be assigned at this point. By default the device access on WAN is disabled. You may enable it by console command. 
 Console>system appliance_access enable 
 You may need to go through the initial setup wizard to complete the process and need an internet connection for the same. After the Wizard you may set device access enable for WAN for HTTPS and disable the appliance access in the console.