portMGMT Unplugged after 16.05.03 MR-3

Question

Hi, 
 After applying firmware upgrade 16.05.03 MR-3, the peer administration port (portMGMT in XG-430) used in HA active-passive mode is detected as "unplugged". 
 I know, check wiring, etc. But it was active a few seconds before installing and the devices are at a data center with hardly any human access so all points to a bug in the release or the process itself (unless otherwise it is proven innocent) ;-). 
 I've tried to switch off the interface (put to "none") and back but being in HA, I would have to undo the feature first which I'm not sure if it'll help in the first place. Any hints? 
 Thanks!

@wajdiaa · Accepted Answer

Hi again, 
 Just to let you all know that the interface is up again after a reboot! 
 Thank you all for your help!

Aditya Patel · Answer

Hi WajdiAyach, 
 I would need two things from your device , 
 1. Snap Shot of the port with the connected ethernet cable connected to a system and Check if the LED is blinking or not. 
 2. I would need Output of Syslog.log and dmesg 
 Command in Shell Access 
 cat /log/syslog.log 
 dmesg

Aditya Patel · Answer

Hi WajdiAyach, 
 According to the logs provided, we could not determine the issue. As your Device was in HA a reboot would be an issue . But Since you were ready for a Reboot, that was a recommended action to resolve your issue. If you face the issue again , I would recommend enabling FSCHECK on your console. 
 The command to Enable|Disable|Status FSck Console> system fsck-on-nextboot on|off|show