Problem Setting Source Network as Port in Rules

Question

I'm setting up Rules and I have a problem when I try to set the Source Network to a specific Port number. The Rule works when I set Source Network to ALL, but not to a specific Port (1 or 4). When I specify a Port, all traffic stops. 
 
 When set to ALL, I can see the traffic in the log files as originating on Port 1 (matches where the cable is attached!). 
 
 The Ports themselves are set up, although this should not impact using ALL or a Port number in the Rules.

What have I missed? Is there a setup step or setting somewhere that is still needed? 
 
 Thanks

lferrara · Accepted Answer

Robert, 
 If you put source port inside the firewall rule, the rule is not applied anymore and trafffic is dropped. Use source network instead or put the 2 different physical ports into 2 different zones and use source zone instead. 
 Regards

Aditya Patel · Answer

HI Robert , 
 On XG if you specify the ports then it would not work , Its a Known Behavior and you may need to specify the Network host . This is also applicable to SSL VPN as well.