Hi,
I read several posts before downloading this, and I knew it required (2) ethernet ports, but that it also supported dot1q, so I thought I would evaluate it anyhow.
At home, I have a single ethernet port connecting to my switch, and trunk to it for everything. I have my VDSL modem on a vlan, and all of my internal subnets on their own vlans, etc...
Well, when I boot this thing up now, it goes into failsafe mode due to the limited NICs. Is there a way around this? If not, does anyone know if I pop a NIC card into this thing temporarily to bypass failsafe, and then take it back out, will subsequent boots still go into failsafe mode? I would permanently add one, but it is a specialized case for this board and has no physical space to allow me to keep one (or a cutout for a second one anyhow).
I would hate to have to spend a couple hundred bucks on a new board / case to evaluate this :)
TIA,
Greg
This thread was automatically locked due to age.
