This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Report of bytes used yesterday in Control Centre is way off...

Just noticed some strangeness in the Reports section of Control Centre. The part that lists the bytes used yesterday is showing an usually large number (see attached screen snippet). There is no way that there could have been 2.6 GB of data uploaded inside of 24 hours. Obviously not a critical issue, just not very informative.

This thread was automatically locked due to age.

Parents

0 just4fun over 8 years ago

Oops, forgot to mention that I'm running XG v16.05.1 MR-1
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 8 years ago in reply to just4fun

I think there is something wrong with maybe your webbrowser. If you check carefully you will see you appear to have given away, due to negative total.

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk over 8 years ago in reply to just4fun

I think there is something wrong with maybe your webbrowser. If you check carefully you will see you appear to have given away, due to negative total.

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 sixteen again over 8 years ago in reply to rfcat_vk

Minus sign will be caused by confusion of 32 bit signed or unsigned integer.

32 bit counters, as used in older snmp versions , should be replaced by 64bit. It only take a couple of minutes at 1G speed to send 2^32 bytes...and overflow the counter
Cancel
Vote Up 0 Vote Down

Cancel