Guest Wireless Network - Allow Internet Access

Check your firewall rule, probably you has set the settings for an interface and you need to add the new one for wireless. Is what i think for now.

Sorry, I don't quite understand. Add the interface where?

Chris,

can you share the firewall rule you have created?

Is your AP and computers using the XG port 4 as default gateway and DNS?

Thanks

Wasn't using the XG for DNS but was for the default gateway. 

I deleted the rule because I couldn't get anything to work :(

Chris,

send me a PM and I wil try to help you.

Regards,

The problem on the Chris configuration was the ip address.

Both Port 4 and Port4.200 (VLAN) were using 2 different IP but in the same subnet.

The trick was to change the Port4 IP to another one not used inside the XG and create a Policy Rule where Wi-FI custom zone to WAN with HTTP/S and DNS were allowed.

All good!

Seriously thank you for your help! You are a life saver!

Hate to bring up an old thread here but for some reason on our phones I can't connect to our Mitel MiCollab Client app to change our status when we are the Guest W-Fi. It works great if we turn off our Wi-Fi and use Cellular but I for the life of me can't figure why when people are on the Guest Wi-Fi we can't connect to the Mitel MiCollab client. 

I believe it may have something to do with NAT & Routing and Masquerading. If I turn off Masquerading I am able to connect to the MiCollab client but then the internet shuts down for the Guest W-Fi network. I just don't get it....

Any help would be greatly appreciated! Thanks.