Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 13 replies
  • Answers 2 answers
  • Subscribers 27 subscribers
  • Views 19870 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to translate ipv4 to ipv6

Mario Ostwald

I have an ipv4 camera in my local lan (sadly doesnt support ipv6). Sophos Xg  has ipv6 wan.

How can i access my camera with ipv4 over the internet?

Thanks for help.



This thread was automatically locked due to age.
Parents
  • 0

    Hi Mario,

    Go to Network> Interfaces> IP tunnel. Here, you will find various options like:

    •  6in4 Tunnel: It is commonly referred as Manual Tunnel and used for IPv6 to IPv6 communication over IPv4 backbone. The source 
       and destination IPv4 addresses must be manually configured. It is recommended for point-to-point communication.     
    •  6to4 Tunnel: It is commonly referred to as Automatic Tunnel and used for IPv6 to IPv6 communication over IPv4 backbone. The destination 
       IPv4 address of the tunnel can be automatically acquired, but the source address needs to be provided manually. It is recommended for 
       point-to-multi point communication.
    •  6rd Tunnel: It is used for IPv6 to IPv6 communication over IPv4 backbone. The 6RD tunnel is an extension of the 6to4 Automatic Tunnel. 
       The tunnel can be established by pre-defined ISP provided prefix.
    •  4in6 Tunnel:It is used for IPv4 to IPv4 communication over IPv6 backbone, the source and destination IPv6 addresses must be manually 
       configured. It is recommended for point-to-point communication. 
     
    Any help with that?
  • 0 in reply to sachingurung

    yes i saw that but i have only a public ipv6 and camera has only a local ipv4.

    4 in 6 tunnel could be right for that?

Reply Children
No Data