Need to do NAT Reflection in the new UI

Question

I have found this: https://community.sophos.com/products/xg-firewall/f/network-and-routing/73239/nat-reflection 
 and this: 
 https://community.sophos.com/products/xg-firewall/f/network-and-routing/73615/how-do-you-create-a-loopback-hairpin-nat-to-an-interface-ip 
 on setting up NAT Reflection. I get stuck on the first step to setup a "Non HTTP Based Policy" Business Rule. I don't see "Non HTTP Based Policy" anywhere. and the other templates don't have the same options like the ones talked about in the guides. Are these guides for the old UI before the recent update? How do I set this up with the new UI? Thanks for any help.

lferrara · Accepted Answer

Clint, 
 On v16 you can create business application rule and select the template dnat and then proceed with the rest of configuration. In v16 it changed again.

Clint Smith · Answer

Thank you. I needed to select the "DNAT/Full NAT/Load Balancing" template. But the steps are referring to sections that are not there. This is what I did and it worked. Although I have to clone the rule for every server I need this on. 
 Section: Source 
 Source Zones: Any 
 Allowed Client Networks: Any 
 Blocked Client Networks: [blank] 
 Section: Destination and Service 
 Destination Host/Network: Port2 (External IP) 
 Forward Type: Port 
 Service Port Forwarded: [NAT port] Select TCP or UDP. If you need both make another rule. 
 Section: Forward To 
 Protected Server: [IP or alias of server] 
 Mapped Port Type: Port 
 Mapped Port: [application port on the server] 
 Protected Zone: LAN 
 Section: Advanced 
 Use outbound Address: MASQ