This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Client Isolation not working on XG Home Firewall with AP55

I have install a Sophos XG Home firewall with an AP55. I create a wireless guest network with following settings:

Security Mode: WPA2 Personal
Client Traffic: Separate Zone
Zone: WiFi
IP address: 192.168.235.254
Netmask: 255.255.255.0
Encryption: AES
Frequency Band: 2.4 and 5 GHz
Client Isolation: Enabled
Hide SSID: Disabled
Fast Transition: Disabled

Client Isolation is not working. Each client can reach other clients in the same guest network. Is there anybody the knows how to configure client isolation that wireless clients couldn't reach other clients? Or is this a bug in the XG firewall?

Thank you!



This thread was automatically locked due to age.
Parents
  • Hi and welcome,

    this is a bit of a guess because I have never tried isolation, but what does your firewall rule allow?

    I suspect you would need a rule something like destination -> any -> any 

    source wifi -> port #1

    My thoughts.

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • Thanks for reply! Could you explain what you mean with a firewall rule concerning client isolation? 

    Normally client isolate clients with each other in the same network and have internet access. And no firewall rules are needed.

  • Enabling Client isolation will prevent the communication on the same network , no further instruction in the XG guide that confirm that new rule  should be attached to operate with this option

     

    Is your firmware is up to date on the XG & AP ?

Reply Children