Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Captive portal on V16

Dear Sir,

After I upgrade firmware to V16.

The captive portal will show a block page first, and then user need to click the link under it to redirect to captive portal.


It is very inconvenient!

Anybody knows how to skip the block page, and show the Captive Portal directly as V15?

Thanks for your kindly help!



This thread was automatically locked due to age.
Parents Reply
  • Thank you Aditya.

    Today I had the time to test the Captive Portal and I can say it works in my case.

    Steps to make the Captive portal working without link:

    • Adjust the Captive Portal Settings under Authentication > Services like below:

    • On the LAN to WAN Rule where only HTTP and HTTPS services are allowed; mark the checkbox "Show Captive portal to unknow users" and match know users"

     

    Wait for a couple of minutes . If the "Show captive portal to unknow users" is not selected, the Captive Portal shows the message with the link to captive portal like v16.

    Let's wait for other user's feedbacks.

    Thanks a lot!

Children