Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

User portal - Remote access

Dear all.

I have configured my XG firewall for VPN SSL Access. However, I am not able to access the User Portal on a public network using https://myXG public address:port

I changed my https port from 443 to XXX on the firewall and I port forward on my ISPs mikrotik router- could this be the reason? Pointers in the right direction would be greatly appreciated.

Kind regards,

Tony.



This thread was automatically locked due to age.
Parents
  • Tony,

    it should work if you did correctly. Can you share your User Portal configuration?

    Thanks

  • Hi Luk,

    Thanks for your reply. First of all my setup is as follows:     

    My problem is that my Sophos is behind the Mikrotic router supplied by my ISP.  Internally, my Sophos ip address is 10.137.10.2. However my WAN IP (which is assigned to the Mikrotic is 41.x.x.x. I have followed the VPN SSL config guide to the book and managed to download and install the VPN Client configurations using the local network. However, when I am outside the private/local network, I cannot even access the Sophos using the WAN IP which has already been forwarded with my SSL port .

Reply
  • Hi Luk,

    Thanks for your reply. First of all my setup is as follows:     

    My problem is that my Sophos is behind the Mikrotic router supplied by my ISP.  Internally, my Sophos ip address is 10.137.10.2. However my WAN IP (which is assigned to the Mikrotic is 41.x.x.x. I have followed the VPN SSL config guide to the book and managed to download and install the VPN Client configurations using the local network. However, when I am outside the private/local network, I cannot even access the Sophos using the WAN IP which has already been forwarded with my SSL port .

Children