This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG Home: Supported 10G NIC

Brand new install of XG with a home license on SuperMicro whitebox server. I have a QLE8442-CU2 NIC installed. XG is not detecting it. It shows the 2x integrated Gbe NIC though. How do I get the 10G interfaces to show up? The driver is present (bnx2x), just no ports.

This thread was automatically locked due to age.

Parents

0 JonBane over 8 years ago

The NICs are supported in UTM 9.

https://sophserv.sophos.com/repo_kb/118185/file/118185_HCL9001.pdf

NetXtreme II BCM57840 10/20 Gigabit Ethernet By Broadcom Corporation
Cancel
Vote Up 0 Vote Down

Cancel
0 JonBane over 8 years ago in reply to JonBane

Found the issue. Unsupported optics. The drivers down the port when not supported.

Is it possible to pass kernel flags? You can pass the module flag "bnx2x.allow_unsupported_sfp=1" to have the driver ignore it.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 JonBane over 8 years ago in reply to JonBane

Found the issue. Unsupported optics. The drivers down the port when not supported.

Is it possible to pass kernel flags? You can pass the module flag "bnx2x.allow_unsupported_sfp=1" to have the driver ignore it.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data