Configuring OSPF XG 430

Hi all

I am new to using sophos and am currently trying to configure OSPF between Sophos and a DELL 6248 and Cisco 3560.

Port A1 is configured with 10.17.0.1 /30

and OSPF;

router-id 1.1.1.1

network 10.17.0.0 /30 area 0.0.0.0

On the Cisco;

router ospf 1

router-id 2.2.2.2

network 10.17.0.0 0.0.0.3 area 0

The status stays in init.

Swap the Cisco for the dell and do the same config, except with dell there is no "no switchport" command so..

interface vlan 5

ip address 10.17.0.2 255.255.255.252

ip ospf area 0.0.0.0

The interface on the dell connecting to the Sophos is in access vlan 5.

I can ping from the sophos to the dell/cisco but i cannot get OSPF to form an adjacency, Sophos doesn't even show them in the neighbors, at least on the switch side, they see the Sophos and are in initialization mode.

Any ideas?

Thanks