How to block port 8094 on Sophos XG?

Question

Hi, 
 After doing a port scan I can see that port 8094 is open on the WAN interface for my home firewall. I have my clients on the UTM 9 at the moment, and if they were to "upgrade" to the XG then this would fail PCI compliance (self signed certificate, I know I could buy one!). Is there any way to firstly find out what the port is being used for and secondly to disable it. 
 Thanks 
 Ned

AllanD · Accepted Answer

Unknown said: 
 I haven't found a way to disable but you can remove "Any Interface" and set it to use 1 that either isn't in use or isn't externally available.

Thank-you. I couldn't find where it was, finally found it under Email -> Encryption -> SPX Portal Settings. I assigned it to my LAN port instead of Any and now it doesn't show on scans. There should be a option for "None" though or the ability to just disable it. 
 
 -Allan

EdwardAshley · Answer

I found it - SPX Configuration!!

D2v2 · Answer

I haven't found a way to disable but you can remove "Any Interface" and set it to use 1 that either isn't in use or isn't externally available.