Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 26 subscribers
  • Views 4931 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Exclude WAN interface from Load Balancing - Or use a non WAN interface for a VPN endpoint?

BrentMagnant

I have an XG with 2 public WAN interfaces (for internet access) and 1 private WAN interface (for private VPN connections).

I want to configure the device to only use the public WAN interfaces for load balancing, and to not use the private WAN. If I change the private WAN to another zone, I can't use it for a VPN endpoint. On the SG I could have set the weighting on the private WAN to zero, but that isn't allowed on the XG.

Thoughts?



This thread was automatically locked due to age.
Parents
  • 0

    Hi Brent,

    Configure private WAN to work as backup line. This will exclude the private WAN link from taking part in load balance. Later, you can select this backup line as a Route through gateway with the firewall rule as per the requirement.

    Hope that helps.

    Thanks

Reply
  • 0

    Hi Brent,

    Configure private WAN to work as backup line. This will exclude the private WAN link from taking part in load balance. Later, you can select this backup line as a Route through gateway with the firewall rule as per the requirement.

    Hope that helps.

    Thanks

Children
No Data