Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 6 replies
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 38078 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

QoS VoIP.ms

MichaelGonzalez

I'm trying to setup QoS for voip.ms (vancouver server). I setup a traffic shaping policy but cant seem to get anything meaningful setup. I am hoping someone has a walk through of how to set this up.

Thanks



This thread was automatically locked due to age.
Parents
  • 0

    Thanks!! I did this. But don't I need to also add the RTP ports? I also don't notice any traffic going through the policy. The UDP port is correct. VoIP.ms uses SIP: 5060 UDP RTP Range: 10001-20000 UDP

    I have attached the screenshots. 

  • 0 in reply to MichaelGonzalez

    Thanks!! I did this. But don't I need to also add the RTP ports? I also don't notice any traffic going through the policy. The UDP port is correct. VoIP.ms uses SIP: 5060 UDP RTP Range: 10001-20000 UDP

    Absolutely!  Just doing SIP 5060 isn't going to do much of anything for you.  SIP is just signalling, very minimal traffic.   The RTP stream is carrying your voice packets and is the important traffic to provide QoS to.  That KB article is not complete.

    So, you want to create the RTP service.  And you also want to create FQDN hosts for the voip.ms servers (single or group depending on your needs).  This will ensure the policy is only applied to traffic to those destinations and doesn't catch other UDP traffic on those ports.

    Then set the DSCP and apply the QoS policy.

  • 0 in reply to DavidWilliams1

    I believe this worked! Thanks a lot for the help! 

Reply Children
No Data