This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No Acess after setting wizard to bridge mode

I tried to set via the wizard tobridge mode, after that i have no acess anymore. Only 2 of the 8 lan ports are active and on both i have no acess. I checked the adress via console and everything is fine.

What can i do?

This thread was automatically locked due to age.

Parents

0 lferrara over 9 years ago

Daniel,

make sure all the ports that belong to the bridge are connected. Go to console and type "system appliance_access enable" and see if you can access the web interface. After that make sure that ports and zone are correctly associated.

Come back here and let us know.

Thanks.
Cancel
Vote Up 0 Vote Down

Cancel
0 DAENG over 9 years ago in reply to lferrara

In device managemnt advanced shell?
Cancel
Vote Up 0 Vote Down

Cancel
0 DAENG over 9 years ago in reply to DAENG

If i boot into another firmware option, will i get back the settings which where active at this point?
Cancel
Vote Up 0 Vote Down

Cancel
0 DAENG over 9 years ago in reply to DAENG

Sorry, its in Main Mneu 4 Console Management
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 9 years ago in reply to DAENG

Using Putty, connect and choose option 4.
Cancel
Vote Up 0 Vote Down

Cancel
0 DAENG over 9 years ago in reply to lferrara

But putty needs a serial cabel right? which is very rare today :)
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 DAENG over 9 years ago in reply to lferrara

But putty needs a serial cabel right? which is very rare today :)
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data