Hi,
I have an AP-100 unit which I want to add to the XG firewall after doing the initial setup. I had to reset to factory defaults as I didn't complete one of the options in the setup wizard, and subsequently had no outbound rules on the firewall.
Anyway, I can see the AP registering in DHCP, and the wireless log has a lot of entries in it regarding not allowing the AP to connect until it is approved. I can see the AP in the wireless AP groups, but can't select it there.
When I go to the Access Points option to approve it, the table of unapproved devices just had a piece of text underneath the table headings suggesting that entries are loading, but nothing ever happens.
Anyone seen this before? Looks like I can't go back to UTM at this stage because the firmware of the AP has updated, so I want to try and get this sorted on XG if I can.
Thanks,
Andrew.
This thread was automatically locked due to age.
