Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 10 replies
  • Subscribers 28 subscribers
  • Views 25837 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VMWare + Transparent Mode/Bridge Mode + DMZ

RayEason

I am running Sophos Home (via VMware ESXI) and have it up and running in Transparent/Bridge mode (behind my pfsense router) but would like to configure it for DMZ as well.

I followed a "How to" for Transparent mode which is working but I am little confused as to how to configure for DMZ (or if doing this after installation will break things).

Easily Evaluate Sophos UTM 9.3 Using Full Transparent Mode:

http://fastvue.co/sophos/blog/easily-evaluate-sophos-utm-9-3-using-full-transparent-mode/



This thread was automatically locked due to age.
Parents
  • 0

    Ray,

    I think you post this thread on the wrong place. You are using a Sophos UTM and not the XG. The steps to configure the XG are a litte bit different than UTM but for both you need an additional virtual switch on Vmware so a dedicated NIC or use VLAN.

Reply
  • 0

    Ray,

    I think you post this thread on the wrong place. You are using a Sophos UTM and not the XG. The steps to configure the XG are a litte bit different than UTM but for both you need an additional virtual switch on Vmware so a dedicated NIC or use VLAN.

Children
No Data