Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 28 subscribers
  • Views 21570 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPPOE connection failing.

DanMiller

 I have an XG105W in a small office with 6 people.  When 2 or 3 are in the office everything seems to work fine, but when everyone begins to get on the internet (usually first thing in the morning) I lose the connection between the XG and DSL modem.  I can log into the admin gui and the interface says "connecting", but it will not connect until I power cycle the DSL modem.  Then everything seems to work fine most of the day.  The log says "Port2: Disconnect PPPoE due to LCP timeout"  Any ideas?  Also I might mention that I tried to set LCP timeout using just the defaults LCP echo and LCP failure, but after I save those changes and go back into the settings it looks like they were not changed.



This thread was automatically locked due to age.
Parents
  • 0

    Hello,

     

    It is most probably speed and duplex mismatch.

    In the advanced port settings, set the Speed at the protocol default (10Mbps - Half Duplex).

    If it works but you need higher speed and full duplex, set both ends at the desired configuration.

     

    Regards,

    Christos Zachos

Reply
  • 0

    Hello,

     

    It is most probably speed and duplex mismatch.

    In the advanced port settings, set the Speed at the protocol default (10Mbps - Half Duplex).

    If it works but you need higher speed and full duplex, set both ends at the desired configuration.

     

    Regards,

    Christos Zachos

Children
No Data