Static routing in SFOS 19.5.1 MR-1-Build278 not working as in 19.0.2 MR-2-Build472 - static route broken

V19.5 introduced a new Engine for Routing (static and Dynamic). But essentially it should not cause problems. Can you check the tcpdump and diagnostic, if those routes are there and the firewall tries to use them? 

I will check tomorrow and get back here

Hi scytherlein : Please also compare #route -n output in both situations to see for the same static route on UI, the back end route in "route -n" is showing or not. You may review  /log/zebra.log, /log/staticd.log /log/csc.log to confirm whether any error getting observed or not. 

Please also, keep an eye on the below thread to confirm if this is related to the below or something different:

Static route gets ignored

I would also suggest logging a support case for further investigation and sharing the case ID here for reference.

Hi

so in GUI all the routes are present, but in CLI with route -n only the first route out of the screenshot is present.

It seems quite similar like mentioned in the link in your reply. But a restart of FW or the zebra service does not solve the problem.

So I'm waiting for the MR3 release of 19.5. 19.0.2 works perfect.

Is there any other workaround you would reccomend for the issue ?

Hi

so in GUI all the routes are present, but in CLI with route -n only the first route out of the screenshot is present.

It seems quite similar like mentioned in the link in your reply. But a restart of FW or the zebra service does not solve the problem.

So I'm waiting for the MR3 release of 19.5. 19.0.2 works perfect.

Is there any other workaround you would reccomend for the issue ?

 scytherlein can you share the /log/zebra.log, /log/staticd.log /log/csc.log and if possible access id in PM to me for Eng team to check on this. -Shrikant

in addition  output of the ifconfig command help. -Shrikant