Sophos Firewall

Discussions POE power cycle on XGS Firewall

Sophos Firewall requires membership for participation - click to join

Thread Info

State Suggested Answer
Locked Locked
Replies 3 replies
Answers 1 answer
Subscribers 27 subscribers
Views 475 views
Users 0 members are here

Options

Suggested

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

POE power cycle on XGS Firewall

Sophos22 over 2 years ago

Hi Community,

is there a way to trigger a poe power cycle on poe ports on xgs firewalls.

This would be very helpful to reboot a poe device remotely.

Thank you.

Kind regards,

Chris

This thread was automatically locked due to age.

Top Replies

Thomas_XG over 2 years ago +1

Hi Chris, did you try to disable the port and re-enable it?

Parents

0 Thomas_XG over 2 years ago

Hi Chris,

did you try to disable the port and re-enable it?
Cancel
Vote Up +1 Vote Down

Cancel
0 Sophos22 over 2 years ago in reply to Thomas_XG

Yes.

There is always POE-Power. Even in case port is disabled. Separate POE-LED is on but standard link LED on port is off in case port is disabled.

Checked on XGS136 Port 11.

According my experience POE power cycle feature is very important.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Sophos22 over 2 years ago in reply to Thomas_XG

Yes.

There is always POE-Power. Even in case port is disabled. Separate POE-LED is on but standard link LED on port is off in case port is disabled.

Checked on XGS136 Port 11.

According my experience POE power cycle feature is very important.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Thomas_XG over 2 years ago in reply to Sophos22

You can raise a feature request within your firewall under "Feedback" on the top of the UI (not visible for Home Licence).
Cancel
Vote Up +1 Vote Down

Cancel