Guest User!
You are not Sophos Staff.
Short question:
What are default values for both option of "set routing sd-wan-policy-route" in the CLI?
The docs could make this more clear, as they only mention, that I *can* turn both on: SD-WAN routing behavior - Sophos Firewall and set - Sophos Firewall
My understanding of activating "sd-wan-policy-route reply packets" will allow asymmetric routing based for reply packets based on SD-WAN Rules on non WAN Interfaces, right?
Hey TheMonzel,
Yes you understood it correct !! And there is no default values for the "system-generate-traffic" & "reply-packet."
Thanks & Regards,
_______________________________________________________________
Vivek Jagad | Team Lead, Global Support & Services
Sophos Community | Product Documentation | Sophos Techvids | SMS
If a post solves your question please use the 'Verify Answer' button.
Hey TheMonzel,
Yes you understood it correct !! And there is no default values for the "system-generate-traffic" & "reply-packet."
Thanks & Regards,
_______________________________________________________________
Vivek Jagad | Team Lead, Global Support & Services
Sophos Community | Product Documentation | Sophos Techvids | SMS
If a post solves your question please use the 'Verify Answer' button.
Yes you understood it correct
Cool 
there is no default values
but it has to be either enabled or disabled. So there should be a setting of new images...
Yes that is correct, we have an option to disable/enable as you mentioned in the KBA above. but again no values to it. Just like 0 or 1/ on or off based on the network traffic challenge symmetric or asymmetric.
Thanks & Regards,
_______________________________________________________________
Vivek Jagad | Team Lead, Global Support & Services
Sophos Community | Product Documentation | Sophos Techvids | SMS
If a post solves your question please use the 'Verify Answer' button.
