This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bridge Interfaces for HA Full Mesh Connected XGS Firewall

Hello Sophos Community,

we have to Layers of Firewalling 2 FortiGates installed in HA AP, and 2 Sophos XGS 3300 installed in AH AP.

We want to connect the Two Layers of Firewalls directly using Full Mesh Connected Topology (The figure in the attachement)

I created a Hardware Switch in The FortiGate (Port1 and Port2 as members inetrfaces), in the Sophos I created a Bridge interface (Port1 and Port2 as members)

the Zone for the First interface member is "WAN", but when I select the "WAN" for the Second member interface, ti's display a message error "Cannot set second member on the WAN Zone"

I'm afraid this configuration doesn't work if I select the DMZ or LAN as Zone Interface for the second Member.

so I want to know is this impact the Topology Configuration ?

Thank you in advance

This thread was automatically locked due to age.