OSPF not enabled on interface

XGS107 (SFOS 19.0.0 GA-Build317

I have OSPF configured and working on another XGS 107.

I have dynamic routing enabled in ADMIN>Device Access.> LAN,

I am using Port 2, which I have changed to LAN.

Under Information OSFP > Interface it shows  ---->>> OSPF not enabled on this interface  ? ?

Port1 is up
ifindex 9, MTU 1500 bytes, BW 0 Kbit
Internet Address 10.0.6.254/24, Broadcast 10.0.6.255, Area 6.0.0.0
MTU mismatch detection:enabled
Router ID 10.0.6.0, Network Type BROADCAST, Cost: 10
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 10.0.6.0, Interface Address 10.0.6.254
No backup designated router on this network
Multicast group memberships: OSPFAllRouters OSPFDesignatedRouters
Timer intervals configured, Hello 10s, Dead 40s, Wait 40s, Retransmit 5
Hello due in 5.862s
Neighbor Count is 0, Adjacent neighbor count is 0
Internet Address 10.20.6.254/24, Broadcast 10.20.6.255, Area 6.0.0.0
MTU mismatch detection:enabled
Router ID 10.0.6.0, Network Type BROADCAST, Cost: 10
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 10.0.6.0, Interface Address 10.20.6.254
No backup designated router on this network
Multicast group memberships: OSPFAllRouters OSPFDesignatedRouters
Timer intervals configured, Hello 10s, Dead 40s, Wait 40s, Retransmit 5
Hello due in 5.862s
Neighbor Count is 0, Adjacent neighbor count is 0

Port2 is up
ifindex 10, MTU 1500 bytes, BW 0 Kbit
OSPF not enabled on this interface 

How do I tell Sophos to enable OSPF on PORT2.  

It must be an ACL from command line ???

Help Please.