Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 8 replies
  • Answers 1 answer
  • Subscribers 28 subscribers
  • Views 1587 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change Interface Zone before Initial Setup via CLI

n33dfull

Hi,

i need to change the Sophos Interface Zone before Initial Setup of Firewall, because i only can access Port2 (WAN).

Actual: 

Port1 LAN - 172.16.16.16
Port2 WAN - 10.128.0.5

Windows Machine to Configure is in the WAN Network 10.128.0.2

I already tried searching for a config file, where i can change the Interface Zone manually and i also done this: 

Console: 

4. Console 

system appliance_access enable 

Then I'm able to access the userportal buut not the WebAdmin or Initialsetup.

Regards



This thread was automatically locked due to age.

Top Replies

  • in reply to n33dfull +1 suggested

    If you boot the firewall for the first time, only LAN (Port1) is accessible. But if you use the command above, wizard will be enabled for all ports. 

    So if you access the CLI, configure the WAN port with an IP, execute the IP, this should work. 

    Jump to answer
Parents Reply Children
No Data