This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos port and passing tagged VLANs

I have a Sophos XG 135 with firmware 18.5.3

I have a small branch office where I replaced the old firewall with the XG.

I informed the office admin to plug in the Meraki Access Point into one of the LAN ports (port 8). The Meraki picked up the reserved IP address correctly, but I am unable to assign DHCP addresses to the wireless devices with the tagged VLAN (let's say VLAN 2). The devices either get a 0.0.0.0 or 169.254.x.x address.

When I changed the SSID to no VLAN tagging (native), the devices pick up an IP address and have connectivity, but they are on the wrong subnet.

Is there a way for the XG LAN ports to pass VLAN tags and make the ports like a trunk port? Is there a config setting I'm missing in order to enable VLAN tagging on a port?

Thanks1

This thread was automatically locked due to age.

Parents

0 Bharat J over 2 years ago

Hi Karnov

Please check VLAN is configured on Sophos XG as per the below link :

https://docs.sophos.com/nsg/sophos-firewall/19.0/Help/en-us/webhelp/onlinehelp/AdministratorHelp/Network/Interfaces/NetworkVLANInterfaceAdd/index.html

Thanks and Regards

"Sophos Partner: Infrassist Technologies Pvt Ltd".

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Karnov over 2 years ago in reply to Bharat J

Ok Thank you. I believe the problem was when I setup the VLANs initially, I assigned them to Port1 and not to br (bridge). I deleted the VLANs and recreated them and assigned them to br (bridge). Hopefully this does the trick. I will find out when my users come into the office. Thanks!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Karnov over 2 years ago in reply to Bharat J

Ok Thank you. I believe the problem was when I setup the VLANs initially, I assigned them to Port1 and not to br (bridge). I deleted the VLANs and recreated them and assigned them to br (bridge). Hopefully this does the trick. I will find out when my users come into the office. Thanks!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Sophos port and passing tagged VLANs

Submitted a Tech Support Case lately from the Support Portal?