Turn 1GBPS INTERFACE SPEED TO LAN

Hello MasterJoker,

if i understand you correctly you talk about that the (internal) speed through your XGS is limited to 100 mbps? If so please check your cabling and maybe test another cable. Also set the setting "Interface speed" to "Auto Negotiation".

The issue you descripe sounds like a defective cable (or maybe a port on the Aruba switch) so the XGS is setting the speed to 100 mbps.

Hi, thanks you Thomas for your response,

I tried to change the cable, with another new cable, and still same problem.

For Aruba, config set, look for LinkSpeed;

but other port is on 1Gbps : 

Hi,

You can not set the interface on XGS on 1000 FDX (fixed) and the switch on auto. You have to set them both on the same setting. Auto for both is the default, but you can also set them both to 1000 FDX.

But you have a problem (port or cable) on the switch or XGS if they can't Auto to 1000 Mbps.

I have multiple XGS's on HPE Aruba CX6x switches without problems, So you may want to check the switch.

For years there is a rare issue with auto negotation, which simply does not work in some setups. To bypass this, you have to set it manually on both ends. 

If you are not doing this, and you run into such a limitation, it will automatically use the slower speed. 

Hi Team,

I've fixed "Auto Negotation" on both, and it's the same issue.

On Aruba Switch, i can't fix "1000 FDX manually", you have "100-full" only and "auto negotation".

Did you try the steps i wrote above with changing the interfaces?

Is the Aruba Switch possibility limited to 100 Full only? If this is the Max for manual setup, it looks like, the Aruba Switch is limited. 

Yes, tried but the same problem.

I tried to do this by cmd "gigaethernet" to the interface, and same problem..

I changed the cable too...

Again, are you sure this port is cable of running more than 100 mbit/s 

It's RJ45 CAT 6 SFTP CABLE;

What do you think if I try "crossover cable?

Please provide a network diagram with the cabling of your network infrastructure and which Aruba 6100 models are you using - e.g. JL675A and which firmware is currently running on it.

Please provide a network diagram with the cabling of your network infrastructure and which Aruba 6100 models are you using - e.g. JL675A and which firmware is currently running on it.

ARUBA 6100 Switch L3 * 48 ports 10/100/1000BASE-T 4 ports 1G/10G SFP

network diagram cabling

Would recommend to talk to Aruba, why you cannot change the speed manually to 1 Gbit/s.