This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After changing the interface, the rule setting must be turned off and then turned on for normal operation

The equipment that connects to the top or bottom of the firewall has changed.

At this time, the snat or dnat policy set on the device is not applied.

You have to turn off the policy and then turn it on for it to work properly.

XG430 (SFOS 17.0.10 MR-10.HF050620.1) version equipment is in use, and it seems to have been resolved in version 18 or higher.
I'd like to find release notes stating that the bug has been fixed.

If anyone knows, please let me know.

thank you.

This thread was automatically locked due to age.

0 rfcat_vk over 3 years ago

Hi,

that is a very old version and not supported. Please upgrade to a later version and check the action.

ian

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 hyun jin over 3 years ago in reply to rfcat_vk

model : xg430

I upgraded to 18.5, but the same symptom occurred.

Is there no such symptom in XGS equipment?

In XG430, the same symptoms continue to occur.
Cancel
Vote Up 0 Vote Down

Cancel

After changing the interface, the rule setting must be turned off and then turned on for normal operation

Submitted a Tech Support Case lately from the Support Portal?