Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 706 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Fresh Sophos XG SW installation , Enable Port 3 to access web admin interface

ali turki

hello

we have server with fixed NIC (2 Fiber Channel ports) and another NIC with 2 copper ethernet ports.
we installed fresh Sophos XG SW on this server , Sophos XG detected FC ports as port 1 and 2, and as we know default configuration is (port 1 is LAN 172.16.16.16 and Port 2 is WAN) and other interfaces disabled. 

we want to access Sophos XG using laptop (no FC ports) and Ethernet cable using (port 3 or 4).
How from CLI we enable Port 3 and access Sophos XG web admin interface using this port ?

thanks



This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    you need to complete the installation and enable the ports using the GUI.

    There's a KBA on CLI commandsn the right hand top corner of the forum

    Ian.

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    hello

    But I can't access GUI because Port 1 and 2 are (FC) and not accessible using my laptop. what do you mean (

    There's a KBA on CLI commands the right hand top corner of the forum) what is the link ?

    thanks

  • 0 in reply to ali turki

    Hi,

    sorry, my previous answer is wrong, I misunderstood your post.

    connect the none fibre ports to active network and perform a fresh installation.

    ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    hello

    So as I understand your answer. If I connect Port 3 to active network and perform fresh installation while port 3 connected, SFOS will automatically  detect port 3 and enable it automatically ,[ not default behavior ports (1 and 2)).

    so I can access GUI using Port3 for first time.

    thanks

Reply
  • 0 in reply to rfcat_vk

    hello

    So as I understand your answer. If I connect Port 3 to active network and perform fresh installation while port 3 connected, SFOS will automatically  detect port 3 and enable it automatically ,[ not default behavior ports (1 and 2)).

    so I can access GUI using Port3 for first time.

    thanks

Children
No Data
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?