This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

installing SW-18.5.2 on XG 125

Hi All

I recently picked up an XG125 as I wanted to install XG home on it, which I have done, but port one (lan) and port two (wan) have no activity and I am unable to connect to the device via https://<IPADDRESS>:4444

Has any had any success with this?

Thanks

This thread was automatically locked due to age.

Top Replies

mayberts over 3 years ago in reply to mayberts +1

It's a shame you can't change the hardware name of the port :(

Parents

0 mayberts over 3 years ago

I have figured it out, for anyone else that runs into this issue.

Port 5 is LAN and port 6 is WAN once the device has been configured you can rename the ports
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 mayberts over 3 years ago

I have figured it out, for anyone else that runs into this issue.

Port 5 is LAN and port 6 is WAN once the device has been configured you can rename the ports
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 mayberts over 3 years ago in reply to mayberts

It's a shame you can't change the hardware name of the port :(
Cancel
Vote Up +1 Vote Down

Cancel

installing SW-18.5.2 on XG 125

Top Replies

Submitted a Tech Support Case lately from the Support Portal?