when I do the install from the bootable USB drive when the PC is set to the UEFI the pc sees the USB drive and then did the install, got to the point where it said to remove the USB drive and reboot the computer. Once I pull the USB drive out and reboot. I get to the screen asking to pick the firmware to boot and will pick the *18.5.2 (yes the * is listed in the choice) and then it looks like it is going to load but just sits there with a back screen. I have waited about 20 min or so to make sure there was nothing hung or just going slow.
I saw on here that UEFI is not supported but when I go looking for more information about this I am seeing that UEFI should be supported in the newer versions of the software.
when I set the PC to the legacy and set the USB floppy to be 1st in the boot list, the PC is not seeing the front USB ports, this could be a pc problem and but they do work when UEFI is enabled
I am using an HP with a 256 SSD drive, 8 gig mem and a A4 AMD possessor.
Any help on this would be great.
This thread was automatically locked due to age.
