This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't adjust members of a bridge interface - GUI timeout

Hello All,

Since upgrading from 18.0.6 MR6 to 18.5.2 MR2 the Wi-Fi SSID associated with the LAN zone via a bridge has stopped working.

I have attempted to create a new bridge however it's not possible to adjust the members of the old bridge, the gui just sits there with a spinning wheel.

This thread was automatically locked due to age.

Parents

0 Bharat J over 3 years ago

Hi Gary McDonald,

Please share the current status of the interface, please go to Configure --->Network --->Interface

Please expand the bridge pair to assist you further with snapshots

Thanks and regards

"Sophos Partner: Infrassist Technologies Pvt Ltd".

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Bharat J over 3 years ago

Hi Gary McDonald,

Please share the current status of the interface, please go to Configure --->Network --->Interface

Please expand the bridge pair to assist you further with snapshots

Thanks and regards

"Sophos Partner: Infrassist Technologies Pvt Ltd".

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Gary McDonald over 3 years ago in reply to Bharat J

Hi Bharat,

In order to fix the issue I have had to roll back to firmware 18.0.6 MR6.

Do you still need/want the screen shots?
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 3 years ago in reply to Gary McDonald

What kind of appliance is this?

__________________________________________________________________________________________________________________
Cancel
Vote Up 0 Vote Down

Cancel
0 Gary McDonald over 3 years ago in reply to LuCar Toni

Hi LuCar,

The device is a XG106w
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 3 years ago in reply to Gary McDonald

And you use the Bridge to use the onboard Wireless module to the local Modul?

__________________________________________________________________________________________________________________
Cancel
Vote Up 0 Vote Down

Cancel
0 Gary McDonald over 3 years ago in reply to LuCar Toni

Yes that's correct.
Cancel
Vote Up 0 Vote Down

Cancel

Can't adjust members of a bridge interface - GUI timeout

Submitted a Tech Support Case lately from the Support Portal?