Sophos XG 18.5 Multiple WAN

Question

Hi all 
 I have 2 WAN, 
 1. WAN1 
 2. WAN2 
 I wan to use WAN1 for these group of internal IPs(192.168.0.5 - 192.168.0.10) and 
 WAN2 for IPs (192.168.0.20 - 192.168.0.30) 
 I was able to change WAN port on version 17.5 
 
 But i can not find this function in 18.5 
 
 And can not even edit it on NAT rules 
 
 Can any 1 plz help me is this possible in this version or if not plz share any link where i can find sophos xg home version 17.5

Bharat J · Accepted Answer

Hi fahad shefaul , 
 Please check out the below video link to meet your same requirement with SD WAN configuration with 18.5v with Sophos XG : 
 https://www.youtube.com/watch?v=TolZsFNbBuM 
 You can add SD WAN rule as per the below snapshot : 
 Please navigate to CONFIGURE -->Routing -->SD WAN policy routing and click on ADD and configure the rule as per the below :

This might help you to meet your requirement

dirkkotte · Answer

please check routing / SD-WAN-Policy-routing

fahad shefaul · Answer

Thank you very much for your quick response, it worked for me thanks again 
 I also want to know how can we configure load balance in sophos xg 18.5 like I have 2 WAN both are 25Mbps, i want to merge them so that i can utilize them as 50Mbps, 
 Hope I was able to make you understand

Bharat J · Answer

Hi Fahad, 
 
 As per your requirement we cannot add the bandwidth provided by different ISPs , however you can load balance the traffic towards WAN between two ISPs. 
 
 Please refer the below link for "Active-active configuration for load balancing" configuration on Sophos XG firewall: 
 https://support.sophos.com/support/s/article/KB-000038337?language=en_US 
 
 On SD WAN rule you have to selecte "WAN link load balance"

Sophos XG 18.5 Multiple WAN

Top Replies

Submitted a Tech Support Case lately from the Support Portal?