Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 1 reply
  • Subscribers 26 subscribers
  • Views 995 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Remove ip address from a physical interface with VLANs

Tijani

Hi,

I have the WAN port and the LAN port with 2 VLANs on each.

Since it is possible from SFOS 18 to have no IP address on physical interfaces with VLANs, I need to get rid of the "dummy" addresses, but :

  • if I uncheck IPV4 configuration on the interface, it wont save and says: 'You must configure at least one IP family".
  • If I set the Zone to "None" on the interface, it warns  me about unbounding the interface.

Can someone please provide guidance on how te remove these IPs preferably without having to re create the VLANs.?



This thread was automatically locked due to age.
Parents
  • +1

    Hello there,

    Thank you for contacting the Sophos Community.

    That is correct, you can create a VLAN on an unbound port, however, if later on or originally you configure the Port with an IP and try to unbind again, the VLAN will get deleted as well. 

    Regards,

Reply
  • +1

    Hello there,

    Thank you for contacting the Sophos Community.

    That is correct, you can create a VLAN on an unbound port, however, if later on or originally you configure the Port with an IP and try to unbind again, the VLAN will get deleted as well. 

    Regards,

Children
No Data