Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 2 replies
  • Answers 2 answers
  • Subscribers 27 subscribers
  • Views 939 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPsec Remote access client can't reach other IPsec clients/SSL VPN clients

Tungmeister

Hi all,

I've setup an IPsec Client Connect client as I'm migrating our users from the SSL VPN client we've used previously. Everything is working fine with regard to reaching the clients from our LANs and the reverse however I can't reach the SSL VPN clients or other IPsec clients from an IPsec client and the same applies from an existing SSL client.

I've configured the network access the same as I did for our LANs under the IPsec settings and applied the same logic to the firewall rules however I just can't get any traffic flowing.

Could anyone advise?



This thread was automatically locked due to age.
Parents
  • 0

    Hi : I have also checked or tested previously such requirements with SSL VPN only, For IPSec remote access not tested or checked -so not sure. However when you are checking the IPSec remote access client connection from another client, what is the observation of TCPDUMP and Drop packet on XG for source and destination IP? Also, any luck for testing if you change tunnel mode from split to full or vice versa to see how it goes?

Reply
  • 0

    Hi : I have also checked or tested previously such requirements with SSL VPN only, For IPSec remote access not tested or checked -so not sure. However when you are checking the IPSec remote access client connection from another client, what is the observation of TCPDUMP and Drop packet on XG for source and destination IP? Also, any luck for testing if you change tunnel mode from split to full or vice versa to see how it goes?

Children
No Data